|.
#decl195#
This command replaces the L^ATEX2.09 command |. There must be exactly one | command in a document; and it must come after the |filecontents| environments, if any, but before any other commands. The <#200#>option-list<#200#> is a list of options, each of which may modify the formatting of elements which are defined in the <#201#>class-name<#201#> file, as well as those in all following | commands (see below). The optional argument <#202#>release-date<#202#> can be used to specify the earliest desired release date of the class file; it should contain a date in the format YYYY/MM/DD. If a version of the class older than this date is found, a warning is issued. For example, to specify a two-column article, using a version of |article.cls| released after June 1994, you specify:

verbatim43#

#decl206#
This command is still supported for compatibility with old files. It is essentially the same as | except that it invokes L^ATEX~2.09 compatibility mode. It also causes any options in the <#211#>option-list<#211#> that are not processed by the class file to be loaded as packages after the class has been loaded. See Section~#Sec:209#212> for more details on L^ATEX~2.09 compatibility mode.
#decl213#
Any number of | commands is allowed. Each package file (as denoted by <#218#>package-name<#218#>) defines new elements (or modifies those defined in the class file loaded by the <#219#>class-name<#219#> argument of the | command). A package file thus extends the range of documents which can be processed. The <#220#>option-list<#220#> argument can contain a list of options, each of which can modify the formatting of elements which are defined in this <#221#>package-name<#221#> file. As above, <#222#>release-date<#222#> can contain the earliest desired release date of the package file in the format YYYY/MM/DD; if an older version of the package is found, a warning is issued. For example, to load the |graphics| package for the |dvips| driver, using a version of |graphics.sty| released after June 1994, you write:

verbatim44#

Each package is loaded only once. If the same package is requested more than once, nothing happens in the second or following attempt unless the package has been requested with options that were not given in the original |. If such extra options are specified then an error message is produced. See Section~#Sec:problems#226> how to resolve this problem. As well as processing the options given in the <#227#>option-list<#227#> of the | command, each package processes the <#228#>option-list<#228#> of the | command as well. This means that any option which should be processed by every package (to be precise, by every package that specifies an action for it) can be specified just once, in the | command, rather than being repeated for each package that needs it.
#decl229#
If this command is placed in the preamble then a list of the files read in (as a result of processing the document) will be displayed on the terminal (and in the log file) at the end of the run. Where possible, a short description will also be produced. Warning: this command will list only files which were read using L^ATEX<#232#><#232#> commands such as | =|<#233#>file<#233#> or |#figure1991#<#234#>file<#234#>. If the file was read using the primitive TEX<#235#><#235#> file input command then it will not be listed.
#decl236#
TEX3 introduced a new primitive || which controls the format of error messages. L^ATEX2_e provides an interface to this through the standard || command. As most L^ATEX users do not want to see the internal definitions of L^ATEX commands each time they make an error, L^ATEX2_e<#240#><#240#> sets this to -1 by default.;''